Add Controller

Controllers are identified on the LAN by their IP addresses. There are three ways you can specify a controller.

IP Address

Tyoe the IP address of the controller. If the controller is on the LAN, the first three octets (numbers) if the address must match the first three octets of the PC’s IP address.

URL

You may specify controllers on the Internet or intranet by their URL.

Scan the LAN

This option allows you to scan all IP addresses of the LAN to identify iNetGrow controllers. There are two scan options. You may broadcast a message to the LAN or specify a start and stop address. Broadcasting sends a single message to all LAN nodes. The latter sends individual messages to the IP addresses in the range. The scan may result in more than one controller. The controller that respond to the scan are shown in a list.

© Rigel Corporation iNetGrow 2003-2006. All rights reserved.